version 1.7, 2011/07/13 15:17:25
|
version 1.8, 2011/07/13 15:18:22
|
Line 43 Here's what I did recently to get [[!te
|
Line 43 Here's what I did recently to get [[!te
|
Bootselector disabled. |
Bootselector disabled. |
First active partition: 0 |
First active partition: 0 |
|
|
(The "PBR is not bootable" line will not appear if you later use [[!template id=man name="installboot" section="8"]] - see step 14 below.) |
(The "PBR is not bootable" line will not appear if you later use [[!template id=man name="installboot" section="8"]]; see step 14 below.) |
|
|
4. Use [[!template id=man name="disklabel" section="8"]] to provide a NetBSD disklabel on each member of the raidset. Create an 'e' partition that describes the whole disk - so it is essentially a copy of the 'c' partition. Make sure that the offset of your 'e' partition is large enough to accomodate any architecture-specific bootstrap requirements, and that the offset is a multiple of the hard drive's native transfer size. |
4. Use [[!template id=man name="disklabel" section="8"]] to provide a NetBSD disklabel on each member of the raidset. Create an 'e' partition that describes the whole disk - so it is essentially a copy of the 'c' partition. Make sure that the offset of your 'e' partition is large enough to accomodate any architecture-specific bootstrap requirements, and that the offset is a multiple of the hard drive's native transfer size. |
|
|