--- wikisrc/set-up_raidframe.mdwn 2011/07/13 15:17:25 1.7 +++ wikisrc/set-up_raidframe.mdwn 2011/07/13 15:18:22 1.8 @@ -43,7 +43,7 @@ Here's what I did recently to get [[!te Bootselector disabled. First active partition: 0 - (The "PBR is not bootable" line will not appear if you later use [[!template id=man name="installboot" section="8"]] - see step 14 below.) + (The "PBR is not bootable" line will not appear if you later use [[!template id=man name="installboot" section="8"]]; see step 14 below.) 4. Use [[!template id=man name="disklabel" section="8"]] to provide a NetBSD disklabel on each member of the raidset. Create an 'e' partition that describes the whole disk - so it is essentially a copy of the 'c' partition. Make sure that the offset of your 'e' partition is large enough to accomodate any architecture-specific bootstrap requirements, and that the offset is a multiple of the hard drive's native transfer size.