--- wikisrc/ports/hp300.mdwn 2012/12/20 14:44:58 1.1 +++ wikisrc/ports/hp300.mdwn 2014/04/18 20:46:30 1.7 @@ -1,7 +1,8 @@ [[!template id=port port="hp300" -cur_rel="6.0" +cur_rel="6.1.4" future_rel="7.0" +pkg_rel="6.0" changes_cur="6.0" changes_future="7.0" thumbnail="http://www.netbsd.org/images/ports/hp300/320.gif" @@ -9,7 +10,7 @@ about=""" NetBSD/hp300 is the port of NetBSD to Hewlett-Packard 9000 Series 300 and 400 workstations. It runs on almost all workstations from this generation. Series 700 and 800 workstations are not currently supported, but work is underway on -[NetBSD/hp700](ports/hp700). +[[NetBSD/hp700|hp700]]. NetBSD/hp300 is based on work done by David P. Davis at the University of California, Berkeley and the Systems Programming Group at the University of Utah @@ -18,12 +19,12 @@ the NetBSD source tree on May 13, 1993. the Systems Programming Group for their work. Without it, the port would not exist. -[hp300 FAQ](ports/hp300faq) +[[hp300 FAQ|hp300faq]] """ supported_hardware=""" All systems with a FPU are supported in NetBSD/hp300 (this excludes the 310 and 332). Systems marked with a "*" do not support the built-in framebuffer. You -will need to [set up a serial console](ports/hp300faq.html#serial400) on these +will need to [[set up a serial console|hp300faq#serial400]] on these machines. The minimal configuration for a NetBSD/hp300 system requires 4M of RAM and about @@ -48,8 +49,8 @@ The minimal configuration for a NetBSD/h * 433s, 433t, 433dl 'note' - > Series 400 machines must be configured in ["HP-UX Compatible Boot Mode". - > Follow these instructions](ports/hp300faq.html#domaintohpux) in the FAQ. + > Series 400 machines must be configured in [["HP-UX Compatible Boot Mode". + > Follow these instructions|hp300faq#domaintohpux]] in the FAQ. Some specific configurations of the above models don't support a local console. The 425e (and some rare 4XXt and 4XXdl machines) have their graphics device on