Return to rockchip.mdwn CVS log

Up to [NetBSD Developer Wiki] / wikisrc / ports / evbarm

add some basic rockchip info.  update pine64 product URLs.

    1: [[!meta title="NetBSD/evbarm on Fuzhou RockChip SoCs"]]
    2: 
    3: NetBSD supports several boards based on RockChip SoCs. Starting with NetBSD 9.0, FDT is used to configure devices. As a result, a large number of boards and configurations can be supported with a single kernel.
    4: 
    5: <img src="https://pbs.twimg.com/media/ENlmzo7UUAIfSM6.jpg" width="300">
    6: 
    7: [[!toc levels=2]]
    8: 
    9: # Supported SoCs
   10: 
   11: <table>
   12:   <thead>
   13:     <tr>
   14:       <th>Family</th>
   15:       <th>SoC</th>
   16:       <th>NetBSD version</th>
   17:       <th>Example boards</th>
   18:       <th>Notes</th>
   19:     </tr>
   20:   </thead>
   21:   <tbody>
   22:     <tr><td>RK3328</td><td>Rock64</td><td>9.0</td><td><a href="https://www.pine64.org/devices/single-board-computers/rock64/">Pine64 Rock64</a><td></td></tr>
   23:     <tr><td>RK3399</td><td>Rock64</td><td>9.0</td><td><a href="https://www.pine64.org/rockpro64/">Pine64 RockPro64</a>, <a href="https://www.pine64.org/pinebook-pro/">Pine64 Pinebook Pro</a><td></td></tr>
   24:   </tbody>
   25: </table>
   26: 
   27: Other systems may work, but they have not been tested.
   28: 
   29: # Supported hardware
   30: 
   31: Please refer to the [GENERIC64 (64-bit)](https://nxr.netbsd.org/xref/src/sys/arch/evbarm/conf/GENERIC64) kernel configs for the most up-to-date list of supported hardware.
   32: 
   33: <table>
   34:   <thead>
   35:     <tr>
   36:       <th>Device</th>
   37:       <th>Supported</th>
   38:       <th>Notes</th>
   39:     </tr>
   40:   </thead>
   41:   <tbody>
   42:     <tr><td>Audio codec</td><td>Yes</td><td></td></tr>
   43:     <tr><td>Framebuffer</td><td>Yes</td><td>Uses simplefb configured by bootloader</td></tr>
   44:     <tr><td>Gigabit Ethernet</td><td>Yes</td><td></td></tr>
   45:     <tr><td>GPIO</td><td>Yes</td><td></td></tr>
   46:     <tr><td>GPU</td><td>-</td><td></td></tr>
   47:     <tr><td>I2C</td><td>Yes</td><td></td></tr>
   48:     <tr><td>I2S/PCM</td><td>Experimental</td><td></td></tr>
   49:     <tr><td>NAND</td><td>Yes</td><td></td></tr>
   50:     <tr><td>P2WI/RSB</td><td>Yes</td><td></td></tr>
   51:     <tr><td>PCIe</td><td>-</td><td>H6</td></tr>
   52:     <tr><td>PWM</td><td>Yes</td><td></td></tr>
   53:     <tr><td>RTC</td><td>Yes</td><td></td></tr>
   54:     <tr><td>SATA</td><td>Yes</td><td></td></tr>
   55:     <tr><td>SD/MMC</td><td>Yes</td><td></td></tr>
   56:     <tr><td>SMP</td><td>Yes</td><td></td></tr>
   57:     <tr><td>SPDIF</td><td>-</td><td></td></tr>
   58:     <tr><td>SPI</td><td>Yes</td><td></td></tr>
   59:     <tr><td>Thermal sensors</td><td>Yes</td><td></td></tr>
   60:     <tr><td>UART</td><td>Yes</td><td></td></tr>
   61:     <tr><td>USB 2.0</td><td>Yes</td><td></td></tr>
   62:     <tr><td>USB 3.0</td><td>Yes</td><td></td></tr>
   63:     <tr><td>Watchdog timer</td><td>Yes</td><td></td></tr>
   64:   </tbody>
   65: </table>
   66: 
   67: # Installation
   68: 
   69: - Download or build **arm64.img** (64-bit) from NetBSD 9.0 or later
   70: - Write the image to disk: **dd if=armv7.img of=/dev/rld0d bs=1m conv=sync**
   71: - Install a board-specific U-Boot (2018.05 or later) from pkgsrc to the SD card
   72:   **dd if=/usr/pkg/share/u-boot/&lt;boardname&gt;/rkspi_loader.img of=/dev/rld0d seek=64 conv=sync**
   73: 
   74: If your SoC has a SATA controller and you would like to install on
   75: an hard disk and use a SD card only for u-boot please give a look
   76: to
   77: [[NetBSD/evbarm install via sysinst(8) on a SATA hard disk, USB stick or (u)SD card|ports/evbarm/install_using_sysinst]].
   78: 
   79: # Tips and tricks
   80: 
   81: # Links
   82: 
   83: - [[NetBSD/evbarm install via sysinst(8) on a SATA hard disk, USB stick or (u)SD card|ports/evbarm/install_using_sysinst]]