Diff for /wikisrc/ports/evbarm/raspberry_pi.mdwn between versions 1.45 and 1.47

version 1.45, 2016/08/03 16:10:22 version 1.47, 2017/03/30 15:53:47
Line 26  Initial, limited, Raspberry Pi support w Line 26  Initial, limited, Raspberry Pi support w
   
            edit cmdline.txt and remove '"console=fb"'             edit cmdline.txt and remove '"console=fb"'
   
    - Most (all?) USB-to-TTL serial adapters only connect Tx, Rx and ground, and do not connect any flow control lines. An effect of missing flow control is that you see console output, but cannot type anything. If so, adjust your serial console application's flow control settings to "none".      - Most (all?) USB-to-TTL serial adapters only connect Tx, Rx and ground, and do not connect any flow control lines. An effect of missing flow control is that you see console output, but cannot type anything. If so, adjust your serial console application's flow control settings to "none".
   
       In Kermit, the command is "set flow none".        In Kermit, the command is "set flow none".
   
Line 99  to test whenever you try new firmware: Line 99  to test whenever you try new firmware:
 - Serial/framebuffer console  - Serial/framebuffer console
 - CPU frequency scaling  - CPU frequency scaling
   
   That goes for all of `rpi[0123]`.
   
 Upstream firmware releases are  Upstream firmware releases are
 [on GitHub](https://github.com/raspberrypi/firmware/releases).  [on GitHub](https://github.com/raspberrypi/firmware/releases).
 Copy all files except `kernel*.img` into `/boot` and reboot.  Copy all files except `kernel*.img` into `/boot` and reboot.
Line 111  Copy all files except `kernel*.img` into Line 113  Copy all files except `kernel*.img` into
           /Users/feyrer/work/NetBSD/cvs/src-current/obj.evbarm-Darwin-XXX/sys/arch/evbarm/compile/RPI2/netbsd            /Users/feyrer/work/NetBSD/cvs/src-current/obj.evbarm-Darwin-XXX/sys/arch/evbarm/compile/RPI2/netbsd
          ...           ...
   
  - Besides the "netbsd" kernel in ELF format, there is also a "netbsd.bin" kernel that is in a format that the Raspberry can boot.    - Besides the "netbsd" kernel in ELF format, there is also a "netbsd.bin" kernel that is in a format that the Raspberry can boot.
  - Depending on your hardware version, copy this either to /boot/kernel.img (old/V1 hardware) or to /boot/kernel7.img (new/V2 hardware)   - Depending on your hardware version, copy this either to /boot/kernel.img (old/V1 hardware) or to /boot/kernel7.img (new/V2 hardware)
  - reboot   - reboot
   

Removed from v.1.45  
changed lines
  Added in v.1.47


CVSweb for NetBSD wikisrc <wikimaster@NetBSD.org> software: FreeBSD-CVSweb