--- wikisrc/ports/evbarm/raspberry_pi.mdwn	2018/11/07 00:56:20	1.108
+++ wikisrc/ports/evbarm/raspberry_pi.mdwn	2018/11/07 01:10:59	1.109
@@ -52,10 +52,10 @@ Initial, limited, Raspberry Pi support w
 # CPU types
 
  - RPI1 uses "earmv6hf".
- - RPI0 uses "\todo".
+ - RPI0 uses "earmv6hf".
+ - RPI0W uses "earmv6hf".
  - RPI2 uses "earmv7hf".
  - RPI3 uses "earmv7hf".
- - RPI0W uses "\todo".
 
 Note that one can run a build of earmv6hf on the 2 and 3.  There will still be a kernel7, built to use the 2/3 hardware, but with the armv6 instruction set.
 
@@ -126,7 +126,7 @@ The standard approach is to use a USB ke
 
 By default the rpi.img is set to use the HDMI output.  If you wish to use a serial console, mount the FAT32 partition on another system and edit cmdline.txt and remove '"console=fb"'.
 
- - Most (all?) USB-to-TTL serial adapters have wires for Tx, Rx and ground, and not RTS/CTS or other flow control lines.   Thus, your terminal program (or terminal) must be configured to not require flow control; a symptom of misconfiguration is that you see console output, but cannot type anything.  If so, adjust your serial console application's flow control settings to "none".
+ - Most (all?) USB-to-TTL serial adapters have wires for TX, RX and ground, and not RTS/CTS or other flow control lines.   Thus, your terminal program (or terminal) must be configured to not require flow control; a symptom of misconfiguration is that you see console output, but cannot type anything.  If so, adjust your serial console application's flow control settings to "none".
 
    - In Kermit, the command is "set flow none".
    - In minicom, run "minicom -s" and set hardware flow control to "no".