[BACK]Return to raspberry_pi.mdwn CVS log [TXT] [DIR] Up to [NetBSD Developer Wiki] / wikisrc / ports / evbarm

Diff for /wikisrc/ports/evbarm/raspberry_pi.mdwn between versions 1.108 and 1.109

version 1.108, 2018/11/07 00:56:20 version 1.109, 2018/11/07 01:10:59
Line 52  Initial, limited, Raspberry Pi support w Line 52  Initial, limited, Raspberry Pi support w
 # CPU types  # CPU types
   
  - RPI1 uses "earmv6hf".   - RPI1 uses "earmv6hf".
  - RPI0 uses "\todo".   - RPI0 uses "earmv6hf".
    - RPI0W uses "earmv6hf".
  - RPI2 uses "earmv7hf".   - RPI2 uses "earmv7hf".
  - RPI3 uses "earmv7hf".   - RPI3 uses "earmv7hf".
  - RPI0W uses "\todo".  
   
 Note that one can run a build of earmv6hf on the 2 and 3.  There will still be a kernel7, built to use the 2/3 hardware, but with the armv6 instruction set.  Note that one can run a build of earmv6hf on the 2 and 3.  There will still be a kernel7, built to use the 2/3 hardware, but with the armv6 instruction set.
   
Line 126  The standard approach is to use a USB ke Line 126  The standard approach is to use a USB ke
   
 By default the rpi.img is set to use the HDMI output.  If you wish to use a serial console, mount the FAT32 partition on another system and edit cmdline.txt and remove '"console=fb"'.  By default the rpi.img is set to use the HDMI output.  If you wish to use a serial console, mount the FAT32 partition on another system and edit cmdline.txt and remove '"console=fb"'.
   
  - Most (all?) USB-to-TTL serial adapters have wires for Tx, Rx and ground, and not RTS/CTS or other flow control lines.   Thus, your terminal program (or terminal) must be configured to not require flow control; a symptom of misconfiguration is that you see console output, but cannot type anything.  If so, adjust your serial console application's flow control settings to "none".   - Most (all?) USB-to-TTL serial adapters have wires for TX, RX and ground, and not RTS/CTS or other flow control lines.   Thus, your terminal program (or terminal) must be configured to not require flow control; a symptom of misconfiguration is that you see console output, but cannot type anything.  If so, adjust your serial console application's flow control settings to "none".
   
    - In Kermit, the command is "set flow none".     - In Kermit, the command is "set flow none".
    - In minicom, run "minicom -s" and set hardware flow control to "no".     - In minicom, run "minicom -s" and set hardware flow control to "no".
Removed from v.1.108  
changed lines
  Added in v.1.109

CVSweb for NetBSD wikisrc <wikimaster@NetBSD.org> software: FreeBSD-CVSweb