--- wikisrc/ports/evbarm.mdwn	2021/09/16 14:33:07	1.105
+++ wikisrc/ports/evbarm.mdwn	2022/03/12 18:27:24	1.106
@@ -18,7 +18,7 @@ implementing the ARM architecture. The "
 to evaluation boards, the original target of the port. However, the
 single GENERIC/GENERIC64 kernel now supports a range of machines including
 development boards, virtual machines, "ServerReady" (SBBR/SBSA) hardware,
-and laptops through both device tree and ACPI based booting.  [Friendly image downloads](http://www.armbsd.org/arm/)
+and laptops through both device tree and ACPI based booting.
 
 [[!toc levels=3]]
 """
@@ -28,36 +28,35 @@ supported_hardware="""
 
 Various CPU variants are supported, e.g:
 
-- evbarm-earmv6hf - ARMv6-A with EABI and hardware floating point, e.g.
+- earmv6hf - ARMv6-A with EABI and hardware floating point, e.g.
   the original Raspberry Pi.
-- evbarm-earmv7hf - ARMv7-A with EABI and hardware floating point, e.g.
-  most recent and common 32-bit ARM boards.
-- evbarm-earmv7hfeb - Same as the above, but with the CPU running in
+- earmv7hf - ARMv7-A with EABI and hardware floating point, e.g.
+  most recent and common 32-bit ARM boards. Supports up to 8 CPUs.
+- earmv7hfeb - Same as the above, but with the CPU running in
   big endian mode.
-- evbarm-aarch64 - 64-bit ARMv8-A boards.
-- evbarm-aarch64eb - Same as the above, but with the CPU running in
+- aarch64 - 64-bit ARMv8-A boards, e.g. all 64-bit hardware.
+  Fully 64-bit kernel and userland. Running 32-bit binaries is supported
+  with `compat32`.
+- aarch64eb - Same as the above, but with the CPU running in
   big endian mode.
 
-Since NetBSD 9.0, 64-bit ARM processors are supported (referred to here
-as aarch64). These run with fully 64-bit kernels and userland. Running
-32-bit ARM binaries is also supported with `compat32`. The 64-bit
-kernel supports up to 256 CPUs and the 32-bit kernel supports up to 8.
-
-Since NetBSD 9.0, there is support for symmetric and asymmetrical
-multiprocessing (aka big.LITTLE).
-
 evbarm variants are little endian unless otherwise stated. NetBSD provides
 big endian images primarily for testing purposes and to ensure that the code
 is endian-clean.
 
 ### Board specific information (often including installation information)
 
+Most ARM boards (unless they have UEFI or Raspberry Pi firmware) require a
+board-specific U-Boot image alongside the generic NetBSD image to be
+written to their storage. In most cases board-specific U-Boot images can
+be built using [pkgsrc](https://pkgsrc.org).
+
  - [[Allwinner sunxi family SoCs|Allwinner]]
  - [[Apple Silicon|Apple]]
  - [[BeagleBone, BeagleBone Black, and PocketBeagle|BeagleBone]]
  - [[NVIDIA Tegra|Tegra]]
  - [[ODROID C1 and C1+|ODROID-C1]]
- - [[Raspberry Pi 1, 2 and 3|Raspberry Pi]]
+ - [[Raspberry Pi 1, 2, 3|Raspberry Pi]]
  - [[RockChip SoCs|RockChip]]
  - [[Terasic DE0 Nano-SoC|Cyclone5]]
 
@@ -71,9 +70,6 @@ based boards, please see the list of
 See the [[NetBSD/evbarm under QEMU|qemu_arm]] page for instructions on how to get started with QEMU.
 """
 additional="""
-### armbsd.org builds
-
-NetBSD developer Jared McNeill provides [builds of NetBSD 9 and -current for a vast variety of hardware.](http://www.armbsd.org/arm/)   In addition to the standard build, these images have board-specific U-Boot contents.  See also /usr/pkgsrc/sysutils/u-boot*.
 
 ### SSH configuration