--- wikisrc/pkgsrc/targets.mdwn	2011/02/07 04:17:45	1.8
+++ wikisrc/pkgsrc/targets.mdwn	2011/02/07 04:23:09	1.9
@@ -8,37 +8,37 @@ Only few of them are useful for regular 
 
 The following targets may be useful to invoke from keyboard:
 
-* "depends" to build and install dependencies
-* "fetch" to fetch distribution file(s)
-* "checksum" to fetch and check distribution file(s)
-* "extract" to look at unmodified source
-* "patch" to look at initial source
-* "configure" to stop after configure stage
-* "all" or "build" to stop after build stage
-* "stage-install" to install under stage directory
-* "test" to run package's self-tests, if any exist and supported
-* "package" to create binary package before installing it
-* "replace" to change (upgrade, downgrade, or just replace) installed package in-place
-* "deinstall" to deinstall previous package
-* "package-install" to install package and build binary package
-* "install" to install package
-* "bin-install" to attempt to skip building from source and use pre-built binary package
+* **depends** to build and install dependencies
+* **fetch** to fetch distribution file(s)
+* **checksum** to fetch and check distribution file(s)
+* **extract** to look at unmodified source
+* **patch** to look at initial source
+* **configure** to stop after configure stage
+* **all** or **build** to stop after build stage
+* **stage-install** to install under stage directory
+* **test** to run package's self-tests, if any exist and supported
+* **package** to create binary package before installing it
+* **replace** to change (upgrade, downgrade, or just replace) installed package in-place
+* **deinstall** to deinstall previous package
+* **package-install** to install package and build binary package
+* **install** to install package
+* **bin-install** to attempt to skip building from source and use pre-built binary package
 
 Cleanup targets (in separate section because of importance):
 
-* "clean-depends" to remove work directories for dependencies
-* "clean" to remove work directory
-* "distclean" to remove distribution file(s)
-* "package-clean" to remove binary package
+* **clean-depends** to remove work directories for dependencies
+* **clean** to remove work directory
+* **distclean** to remove distribution file(s)
+* **package-clean** to remove binary package
 
 The following targets are useful in development and thus may be useful for an advanced user:
 
-* "makesum" to fetch and generate checksum for distributed file(s)
-* "makepatchsum" to (re)generate checksum for patches
-* "makedistinfo" to (re)generate "distinfo" file (creating checksums for distributed file and patches)
-* "mps" short for "makepatchsum"
-* "mdi" short for "makedistinfo"
-* "print-PLIST" to _attempt_ to generate correct packaging list
+* **makesum** to fetch and generate checksum for distributed file(s)
+* **makepatchsum** to (re)generate checksum for patches
+* **makedistinfo** to (re)generate *distinfo* file (creating checksums for distributed file and patches)
+* **mps** short for **makepatchsum**
+* **mdi** short for **makedistinfo**
+* **print-PLIST** to _attempt_ to generate correct packaging list
 (NB! It helps, but it _doesn't_ eliminate manual work.)
 
 For example, package updating looks like this: